Bench type MINDEN 3.0 m with seat support hardwood

The bench supports lie on two cubic blocks (substructure) and are visually integrated into the blocks. All corners on the blocks are rounded.

Material substructure bench:
Corten steel grade S355J2W + N
Material no. 1.8965

Visible sides optically pre-rusted

Material seat support bench:
100% hardwood with quality seal
2x 130x65 mm, 4x 65x65 mm
Edges chamfered

Dimensions bench:
Total length: 3.000 mm
Length wooden seat support: 2.600 mm
Seat depth: 490 mm
Seat height: 475 mm

Width of side support block: 200 mm

Fastening of the bench: Dead weight

Without backrest
Without side support

Foundation: on site

Corten steel with a stainless steel look causes a certain amount of rust peeling of 0.05 mm of the surface, especially in the first few years. We therefore recommend planning the installation in such a way that this rust separation can run off in a defined manner and that no discolouration occurs in the area of the objects.

When combining wooden and corten steel seat cushions, the iron oxide adhering to the surface and the tannic acid present in the wood can cause dark grey and black discolouration of the wooden cushions. This is a natural process in this combination and does not justify a complaint. With increasing natural greying of the wood, the grey spots that appear in advance disappear and the surface colour becomes similar.

Care instructions for wood:
All wood used outdoors greys within a few months and takes on the typical silvery appearance. It is possible to oil the wood with suitable wood preservative oil so that the greying of the wood is delayed. You can find more information on this on our homepage at www.gartenmetall.de