Planter with bench BORKUM 3.0 m x 1.0 m

Mobile planter
with integrated bench on the long side

Material of planter:
Grade S355J2W + N
Material no. 1.8965

Visible sides optically pre-rusted

Dimensions of planter:
Rectangular with all-round bevelling at the top 60 mm and 20 mm, for high stability and round edges

Length: 2,980 mm
Width: 1.000 mm
Height of planter: 500 mm

Height of bench: 475 mm
Height of planter: 25 mm higher than bench
Length of bench: 2,980 mm
Seat depth: 490 mm

Incl. 4 straps for transport and/or attachment of wood
The straps are welded into the corners approx. 100 mm below the top edge for stability. Hole for hooks for hanging: ø40 mm.

Material seat support: RESYSTA®
Edges chamfered

Dimensions bench:
Seat support lengthwise
Type SAL 6x20x70
6 seat beams Cross-section 20x70 mm
Spacing approx. 14 mm

The seat supports are screwed from below with a stainless steel cross-batten so that no fastening screws are visible in the wood from above. The complete pre-assembled seat support is then screwed onto the bench substructure with screws between the seat supports. All screws are of high-quality A2 stainless steel.

Without side rests

To protect the roots from frost and heat damage, we recommend lining the walls with at least 20 mm of insulation made of PUR insulation boards.

Delivery includes base, water-permeable

With corten steel in a stainless steel look, a certain amount of rust detachment of 0.05 mm of the surface occurs, especially in the first few years. We therefore recommend planning the installation in such a way that this rust separation can run off in a defined manner and no discolouration occurs in the area of the objects.