Planter with bench BORKUM 3.0 m x 1.5 m

Mobile planter
with integrated bench on the long side

Material planter:
Stainless steel, rotex ground

Dimensions planter:
Rectangular with all-round bevelling at the top 60 mm and 20 mm, for high stability and round edges

Length: 2,980 mm
Width: 1.480 mm
Height of planter: 500 mm

Height of bench: 475 mm
Height of planter: 25 mm higher than bench
Length of bench: 2,980 mm
Seat depth: 490 mm

Incl. 4 straps for transport and/or fastening of wood
The straps are welded into the corners approx. 100 mm below the top edge for stability. Hole for hooks for hanging: ø40 mm.

Material seat support:
100% hardwood with quality seal
Edges chamfered
Surface planed

Dimensions seat bench:
Seat support lengthwise
Type SAL 6x65x65
Seat beam cross-section 65x65 mm
Distance approx. 20 mm

The seat supports are screwed from below with a cross lath made of stainless steel so that no fastening screws are visible in the wood from above. The complete pre-assembled seat support is then screwed onto the bench substructure with screws between the seat supports. All screws are of high-quality A2 stainless steel.

Without side rests

To protect the roots from frost and heat damage, we recommend lining the walls with at least 20 mm of insulation made of PUR insulation boards.

Delivery includes base, water-permeable

The seat supports are made of wood. Wood is a natural material that can vary in colour. The seat cushions are made exclusively from kiln-dried wood. Despite all care, drying cracks may occur and knots may be visible. These are natural characteristics and do not justify a complaint. Border samples can be matched on request.

Wood care instructions:
All wood used outdoors turns grey within a few months and takes on the typical silvery appearance. It is possible to oil the wood with suitable wood preservative oil so that the greying of the wood is delayed. You can find more information on this on our homepage at www.gartenmetall.de